Page 123
Operation
colorSENSOR CFO
i
After a firmware update, it is recommended to reset the sensor, as the factory settings may also have
You can then load your previously saved parameters
5.7
Factory Reset
A factory reset can be triggered as follows:
Disconnect the controller from the power supply.
Hold the
INT
and
ESC
keys depressed.
Avoid pressing any other keys during this procedure. Otherwise the process can become stuck in an unde-
fined state.
> Damage of the controller
Switch the power supply back on.
Keep the keys pressed for > 2 seconds and then release them as soon as the LEDs start flashing.
The controller then starts resetting to factory defaults
During this operation all controller settings as
well as all firmware updates performed in the meantime are discarded. Resetting requires approx. 5 minutes.
In the event of an error, e.g. interrupted power supply, the reset is continued during the next restart. No color
recognition is indicated and no entries are possible during the reset operation. Key actuation is acknowl-
edged by error flashing (3x100 / 300 ms).
Indicators
Output LEDs:
Pulsating progress bar (indeterminate progress bar)
Key LEDs:
Not illuminated
Power LED:
Illuminated continuously
Key-lock LED:
Illuminated continuously
NOTICE
Summary of Contents for colorSENSOR CFO
Page 7: ...Page 7 colorSENSOR CFO...
Page 8: ...Page 8 colorSENSOR CFO...
Page 96: ...Page 96 Operation colorSENSOR CFO Fig 45 Settings Color table menu...
Page 137: ......
