Page 118
Operation
colorSENSOR CFO
Ethernet set-
tings IPv6
Method
Automatic
Using Stateless Address Autoconfiguration
(SLAAC, specified in RFC 4862), a host
can establish a functional Internet connec-
tion fully automatically. To do this, it com-
municates with the routers responsible
for its network segment to determine the
necessary configuration
.
Dynamic
(DHCP)
DHCP
Host name
Value When DHCP is activated, the controller is
accessible in the network under its DHCP
Host name. With DHCP it may be neces-
sary to enable the controller MAC address.
Static
IP address
Value When using a static IPv6 address, the
values for IP address, prefix length, and
gateway must be specified; this is omitted
when using DHCP or Automatic.
Prefix length Value
MAC address
Value see DHCP
The Ethernet interface is not only used for parameter setting of the measuring system via the web pages or
, but also enables non-real-time data transfer (packet-based data transfer).
The color values for measured value capture are transferred for one subsequent analysis without direct pro-
cess control. Data transmission takes place at a maximum of 15 Hz.
When using a static IP address it is necessary to enter the values for the IP address, Gateway and Subnet
mask; this is not required when DHCP is used. The changed IP settings are active immediately and it may be
necessary to enter the new IP address in the browser to access the web interface again.
The controller is set at the factory to the fixed IP address 169.254.168.150.
The controller transfers the TCP/IP or UDP/IP packages at the Ethernet transfer rate of 10 MBit/s or 100
MBit/s, which is set automatically depending on the network or PC connected.
Fields with gray
background re-
quire a selection.
Val-
ue
Fields with dark
border require
entry of a value.
Summary of Contents for colorSENSOR CFO
Page 7: ...Page 7 colorSENSOR CFO...
Page 8: ...Page 8 colorSENSOR CFO...
Page 96: ...Page 96 Operation colorSENSOR CFO Fig 45 Settings Color table menu...
Page 137: ......
