
4 - CONTROLS AND INSTRUMENTS
4 - 7
REF.
DESCRIPTION
44
Battery charging
With the engine running, the alternator cannot charge the battery correctly.
45
Engine oil pressure
Insufficient oil pressure in the engine.
This warning light illuminates above 1,000 rpm with low engine oil pressure. In this condition stop the engine
immediately and fill up oil. Start the engine again, and see if the warning light switches off.
If the problem persists, please contact the Merlo Technical Support Service.
46
Brake oil level
Insufficient brake oil level. Stop your machine and search for the cause of the problem. Fill up specific oil.
47
Engine air filter clogged
The engine air intake filter is clogged.
Clean the filter. Replace it if necessary.
48
Hydrostatic transmission oil level
Insufficient oil level in the hydrostatic transmission.
Stop your machine and search for the cause of the problem. Fill up specific oil.
49
Hydrostatic transmission oil temperature
High oil temperature in the hydrostatic transmission.
Stop your machine and search for the cause of the problem.
50
Low-beam headlights
Low-beam headlights on. Obey the highway code of the country you are driving in.
51
High-beam headlights
High-beam headlights on. Obey the highway code of the country you are driving in.
52
Blinkers
Blinkers are on in an intermittent mode.
53
Glow plug pre-heat indicator
Preheating of spark plugs for cold engine start
54
Front overturn prevention system
The front overturn prevention system is activated, and all controls are disabled.
55
Crab steering
Crab steering is engaged; proceed with particular caution during transfers.
56
Chassis side-shift
(not applicable to this model)
57
Parking brake
When the drive direction selector is in a neutral position, the parking brake is applied. If this malfunction is shown
even after the parking brake is released, this means that pressure in the system has dropped below the minimum
allowable value (about 18 bar).
87
Engine malfunction
(not applicable to this model)
88
Differential locking device
The differential locking device (available as an option) is engaged.
93
Engine coolant temperature
The engine coolant temperature is too high. Switch off the engine and let it cool down. Check the coolant level
inside the expansion tank.
96
Tail lights
Tail lights on. Obey the highway code of the country you are driving in.
103
Rear PTO
(not applicable to this model)
108
Fuel reserve indicator
Low fuel level in the tank. Fill up.
132
Coolant level
Fill up the engine cooling system with the engine coolant prescribed by the engine manual.
133
Water in the diesel oil
(not applicable to this model)
205
Direction indicators failure for agricultural trailer
(available as an option)
206
Break in the rope for telescopic boom extension
(not applicable to this model)
207
Merlo Service reminder
(not applicable to this model)
208
Malfunction of the hydraulic steering system
(not applicable to this model)
WARNING!
For further information on the dashboard light indicators, refer to chapter "OPERATING INSTRUCTIONS".
Summary of Contents for P25.6
