MERLO P25.6, Instruction Manual, Page: 122 / 232

8 - ATTACHMENTS AND OPTIONAL EXTRA
8 - 2
This chapter describes all the available accessories for this vehicle, based on the Merlo official price list.
Before using any accessory mentioned in the present chapter, it is necessary to read and fully understand the instructions on
its operation. If the accessory installation or operation is not entirely clear, please contact your dealership or Merlo Technical
Support Service.
WARNING!
Only use Merlo S.p.a. approved accessories, homologated for their use on your vehicle.
It is forbidden to use an acessory without reading and understanding its installation and operation instructions.
Should more than one accessory be installed on the machine, the relative controls may be in a position that differs
from that indicated in the manual supplied with the machine. In any event please refer to the symbol that appears next
to the command itself, so that even if it should be in a different position can be identified by the relative symbol which
is described in the manual.
GENERAL INSTRUCTIONS FOR THE USE OF THE MACHINE AS AN AGRICULTURAL TRACTOR (ONLY FOR 25.6)
This paragraph provides general instructions to be followed if your machine is type-approved as an AGRICULTURAL
TRACTOR in compliance with Directive 2010/52/EU.
• PROTECTION LEVEL OF THE OPERATORS PROTECTION STRUCTURE
For information on the protection level of the operators protection structure of your machine please refer to the "CAB TYPE-
APPROVAL PLATE" in chapter "TECHNICAL DATA OF YOUR MACHINE".
• PREVENTION OF CONTACT WITH HAZARDOUS SUBSTANCES
Prevention level 1 in compliance with the EN 15695-1:2009 standards. Cab not suitable for any use implying contact with
hazardous substances.
• HOW TO TOW AN AGRICULTURAL TRACTOR
For information on how to tow your machine if it is type-approved as an AGRICULTURAL TRACTOR (Directive 2010/52/EU)
please refer to the instructions provided in paragraph "MACHINE TOW", chapter "OPERATING INSTRUCTIONS".
• WHERE TO PLACE HYDRAULIC JACKS
Should you lift your machine to replace a tyre, you can apply hydraulic jacks
where shown below:
A) front lifting spot: place your hydraulic jack by the middle part of the front axis
of your machine, as shown by the arrow
B) rear lifting spot: place your hydraulic jack by the middle part of the rear axis of
your machine, as shown by the arrow
Please refer to the "TABLE FOR THE DETERMINATION OF PERMISSIBLE
MASSES, AXLE LOADS AND TYRE LOAD CAPACITIES" in this chapter to
identify the kind of hydraulic jack which best suits your needs.
• GENERAL INSTRUCTIONS FOR THE USE OF ATTACHMENTS OR
TRAILERS COUPLED TO YOUR MACHINE
Before using your machine with mounted attachments, trailers and
interchangeable towed attachments, strictly follow the instructions provided both
in the operation and maintenance manual of your machine and in the manuals of
the attachments or trailers. Never use your machine with mounted attachments,
trailers and interchangeable towed attachments without following said
instructions.
WARNING! Never stand in between the machine and the trailer or
towed attachment.