MC Crypt 30 47 21, Operating Instructions Manual

Page: 42 / 104

42
6. Connections and Control Elements
5) Foot switch (FX FOOTSW)
You can activate or deactivate the effect processor with the foot switch.
6) Headphone jack
Connection jack for stereo headphones (6.3 mm jack plug).
Turn the PHONES/CTRL R control to the “-” position before plugging in, unplugging or put-
ting on the headphones or before switching the mixer on or off. There is a risk of damage to
your hearing through excessive volume at the headphones output.
Outputs on the rear
1) MAIN OUTPUTS
The mixer’s MAIN MIX output signal is applied to the
XLR outputs. Here you can connect a PA amplifier.
The output level is set via the two MAIN MIX sliders.
2) ALT 3 and ALT 4 OUTPUT
The mixer’s ALT 3 and ALT 4 output signal is applied
to these asymmetric 6.3 outputs. Here you can
connect a PA amplifier. The output level is set using
the ALT 3 and ALT 4 sliders.
3) CONTROL ROOM OUT
The mixer’s CONTROL ROOM output signal is applied to these asymmetric 6.3 outputs. The CONTROL ROOM
output is usually used for the monitor system in the control room. The output level is set via the PHONES/CTRL
control.