Revision 1.7.2
Page 79
6.8 Maretron DSM200 Configuration
You can use the DSM410 to configure other remotely-located DSM200 units by using the Remote
DSM200 configuration menu shown in Figure 63 below. This describes the configuration of the
Maretron DSM200 firmware version 1.10. There is one configurable item for the remote DSM200
configuration and that is “
Remote
Device Selection…
”.
Figure 63
– DSM200 Remote Configuration Screen
6.8.1 Remote Device Selection
A DSM410 unit can be used to configure a remote DSM200 to set which NMEA 2000
®
devices are
selected for display on the remote DSM200 unit. In this manner, multiple devices of the same type
may be used on a NMEA 2000
®
network in a fail-safe configuration. For example, a certain compass
unit out of several may be selected for display
on the remote DSM200. The “
Remote Device
Selection…
” menu for an example network configuration can be seen in Figure 64 below.
WARNING
: Do not select multiple devices of the same type for display. This will result in multiple and
possibly conflicting readings.
Figure 64
– DSM200 Remote Device Selection Screen
