Revision 1.7.2
Page 145
Scroll Down
keys to change the J1939 Source Address value until it matches the J1939 source
address of the engine/genset or transmissions for which you desire this J2K100 to translate data onto
the NMEA 2000
®
network.
6.18.7
Refresh J1939 source address list
The configuration screen for the J2K100 will examine the bus to determine to which devices it can
connect. This is presented in a list at the bottom of the screen. To update the list after adding a
device, highlight this entry, and press the
Enter
button.
6.19 Maretron NBE100 Configuration
The DSM410 is capable of configuring the Maretron NBE100 Network Bus Extender. This describes
the configuration of the Maretron NBE100 firmware version 1.0.0. The NBE100 configuration menu is
shown in Figure 144 below.
Figure 144
– NBE100 Configuration Screen
6.19.1
Advanced Configuration
Advanced Configuration changes some complex parameters within the device, and should only be
performed by an advanced user. Typically advanced configuration is only done at installation and
should not need to be done while at sea.
