Revision 1.7.2
Page 27
5.2.1 Alert Setup Menu
Selecting
Alert
Setup…
from the Main Menu allows you to create, delete, and edit the Alerts stored
in the DSM410, and to change the operating mode of the vessel. See section 7.25 for details on the
Alerts.
5.2.2 Alert Status
Selecting
Alert Status
…
from the Main Menu will display a list of currently active Alerts in the
DSM410. See section 8.1.1 for details on the Alert Status Screen.
5.2.3 Configuration Menu
The configuration menu allows you to change the configuration of certain types of Maretron NMEA
2000
®
devices, as well as to select from which NMEA 2000
®
nodes data may be received.
The available options within the Configuration screen are shown in Figure 8.
Figure 8
– Configuration Screen
5.2.3.1 Device Configuration
The ability to calibrate and configure other devices on the bus is a major portion of this manual. For
this reason it has been given an entire section. See section 6 for details.
5.2.3.2 Device Selection
The “
Device Selection…
” menu allows you to enable and disable the display of data from individual
NMEA 2000
®
devices. In this manner, multiple devices of the same type may be used in redundant
and fail-
safe configurations. A typical “
Device Selection…
” menu for a network configuration can be
seen in Figure 9 below.
NOTE:
Now that you can select instances for each displayed parameter, you do not need to configure
this menu. This menu entry is retained for backward compatibility.
