DSM410
User’s Manual
Page 156
Revision 1.7.2
6.21 Maretron RIM100 Configuration
This describes the configuration of the Maretron RIM100 firmware version 1.1.1.
The DSM410 may be used to configure the channels on the Run Indicator Module (RIM100).
After selecting the RIM100 from the list of devices on the network, the following screen will be
displayed.
Figure 160
– RIM100 Configuration Screen
6.21.1
Advanced Configuration
Advanced Configuration changes some complex parameters within the device, and should only be
performed by an advanced user. Typically advanced configuration is only done at installation and
should not need to be done while at sea.
Figure 161
– RIM100 Advanced Configuration Screen
6.21.1.1
Device Instance
This entry allows you to program the NMEA 2000 device instance for the unit. You usually will not
need to modify the default value of “0” unless you have multiple units on the network.
