Section 8 – RCP Programming (Continued)
91
WARNING
IF YOUR UNIT HAS MULTIBOX DO NOT ATTEMPT TO PROGRAM ADDITIONAL TRANSMITTERS IN THE
FIELD. TELEMOTIVE MUST COORDINATE ACCESS CODE ASSIGNMENTS WITH THE NEW TRANSMITTERS
PRIOR TO EXPANDING MULTIBOX. PLEASE CONTACT TELEMOTIVE IF YOU NEED TO ADD ADDITIONAL
TRANSMITTERS. FAILURE TO FOLLOW THIS WARNING COULD RESULT IN SERIOUS INJURY OR DEATH
AND DAMAGE TO EQUIPMENT.
Many receivers have Multibox capability that allows up to 8 transmitters to access a single system. Only one transmitter
may control the receiver(s) at a given time. Access is on a first come first serve basis. Once a transmitter has gained
control, another transmitter may not access the receiver(s) until the controlling transmitter relinquishes control by
transmitting an OFF command to the receiver(s) or the receiver(s) times out due to inactivity.
The first transmitter to send an ON command after the receiver has been released will then gain control of the receiver(s).
The number of transmitters (up to 8 depending on receiver configuration) allowed to control the receiver(s) is dip switch
selectable on the Receiver Board.
NOTE
THE DESIRED MULTIBOX TRANSMITTERS MUST HAVE CONSECUTIVE ACCESS CODES BEGINNING FROM
THE FIRST ACCESS CODE.
8-3.
Programming.
8-3.1.
telePilot
Programming.
Read Section 5-6. Additional
tele
Pilot Operational Features to familiarize you with the features listed below. The
tele
Pilot
transmitter is programmed using the RCP (Radio Control Programmer) software. RCP can be ordered from your Magnetek
distributor.
Magnetek RCP software
is user friendly and is intended to provide plain language descriptions of all transmitter functions
and options. Help is provided for each function at the bottom of the RCP screen. The RCP software allows you to select
frequency, access code, time-out-timer settings, switch arrangement and crane configuration as in other Telemotive
transmitter products. Follow the steps below:
Install the RCP software.
After installation of the RCP Software, double-click the RCP icon
found on the desktop to launch the program.
This will prompt you to enter an activation key. If an activation key is not entered at this time, the software can only be
used 10 times before locking the user out. Contact customer service or your sales representative for an activation key.
