Section 7 - Programming (Continued)
75
10K
telePilot
Programming (Continued).
7-8.1.1.
Single-Speed 10K
telePilot
Only:
Skip to next section7-7.1.2 (below) if 2-speed.
Timer (If unsure of a number start with 15 minutes):
Enables the transmitter time-out-timer. The selections are “None” (meaning the transmitter will never shut off on it own if
not used, this is not recommended for battery life) or numbers of minutes till shut down. The minutes are selectable in one-
minute steps from 1 to 10 and five minutes steps up to an hour. Tap on the “Timer” arrow; scroll down through the number
of minute and tap on the desired number.
Modes 1-3 (The correct mode must be selected for safe operation):
Please refer to
Figure 7-7.
Single-Speed 10K
telePilot
for specific mode details. Modes are various patterns of functional
lockouts. If you have UP and a DOWN buttons on a single-speed transmitter controlling a hoist, the transmitter must not be
able to send Up and DOWN commands at the same time.
Mode determines the respective buttons that are locked out to each other. Modes do NOT change the configurations of the
output relays. Find the desired mode and select its number on the “Mode” selection.
This completes the 10K single-speed programming, when completed with the above tap “Save”.
Save will take you back to the initial start screen and turn the Bank ON. At this point select another Bank to program or go
to Section 7-9. Loading And Saving The Program.
10K Single-Speed
Programming Screen
System
10K
Freq
AK01
Setup Bank #
A1
Receiver access code
1
0
B1
1
0
Multibox
Tx #
1
Auto Turn Off
Timer None
Mode 1
Save
Cancel
