Section 8 – RCP Programming (Continued)
94
The Bank password can be disabled during initial programming by the RCP software. To disable password protection,
uncheck the box next to the phase “Use bank password”. Disabling the Bank password is not recommended unless the
operator has access and visibility to all possible cranes controlled.
WARNING
DISABLING THE PASSWORD FUNCTION PUTS THE SYSTEM IN ACTIVE BANK SELECT. THIS ALLOWS THE
CRANE OPERATOR TO SWITCH BETWEEN BANKS QUICKER. THE OPERATOR IN THIS MODE MUST BE
AWARE AND RESPONSIBLE FOR ALL POSSIBLE CONTROLLED CRANES. FAILURE TO FOLLOW THIS
WARNING COULD RESULT IN SERIOUS INJURY OR DEATH AND DAMAGE TO EQUIPMENT
.
Enable a Bank (At least one must be enabled).
When done with the password section, select the number of the Bank(s) you wish to use and check the cell labeled with the
appropriate Bank number.
You do not have to use all Banks and you do not have to use them in order.
Even after programming a Bank you can turn it back “OFF”. A programmed Bank will not lose its programming by turning
it “off”. By turning ON and OFF Banks you can easily save certain transmitter configurations in the transmitter to turn
them on at a later time with the RCP software without having to completely reprogram them.
Unit ID name
The Unit ID name is retrieved from the transmitter by using the receive button. This is the name and ID that was assigned
to the transmitter on initial programming.
Custom Name
This allows the user to create a name to identify the transmitter. The unit ID name will be overwritten by the custom name.
Bank Programming Screen.
Select the bank you wish to program.
