Section 5 – Operation (Continued)
26
11/11/2014
NOTE
ALWAYS REMEMBER TO STORE THE PASSWORD IN A SECURE LOCATION FOR ACCESS IF
THE PASSWORD IS LOST OR FORGOTTEN. ONCE THE TRANSMITTER IS PROGRAMMED
THERE IS NO WAY TO DEFEAT THE PASSWORD WITHOUT USING A PDA TO EITHER READ
THE PASSWORD OUT OR REPROGRAM A NEW ONE.
The Bank password can be disabled during initial programming by the PDA.
WARNING
DISABLING THE PASSWORD FUNCTION PUTS THE SYSTEM IN ACTIVE BANK SELECT. THIS
ALLOWS THE CRANE OPERATOR TO SWITCH BETWEEN BANKS QUICKER. THE OPERATOR
IN THIS MODE MUST BE AWARE AND RESPONSIBLE FOR ALL POSSIBLE CONTROLLED
CRANES. FAILURE TO FOLLOW THIS WARNING COULD RESULT IN SERIOUS INJURY OR
DEATH AND DAMAGE TO EQUIPMENT
.
telePilot
Time-Out-Timer Function.
The transmitter has a time-out timer and the default condition is 15 minutes. Upon timing out the
transmitter will send an OFF command to the receiver if Auto Turn Off is active. The transmitter time-out-
timer function is programmable in minute increments to up to and including 15 minutes. After that it is
programmable in five-minute increments up to and including one hour. Infinite time-out (none) is also
selectable. The time-out-timer measures the time since the last pushbutton stroke and is continuously reset
by any pushbutton activation.
5-7.
Battery Replacement.
Membrane And Pendant Battery Replacement.
To replace the batteries, turn the transmitter OFF, and then turn the unit over to access back cover. Twist
half moon shaped battery latch to remove cover. Take out old batteries; replace ALL batteries with new
cells. For the Membrane Transmitter note battery orientation, batteries in backwards will blow fuse.
Replace cover and turn transmitter ON to use. See Section 10. Spare Parts for battery and fuse part
numbers.
telePilot
Battery Replacement.
On the
tele
Pilot
if the yellow battery indicator light starts to flash replace the battery at the
earliest opportunity. If the light is on solid replace the battery immediately.
NOTE
THERE IS NO NEED TO RUSH BATTERY REPLACEMENT. THE PROGRAMMING IN THE
tele
Pilot
WILL
NOT
BE LOST BY REMOVAL OF THE BATTERY OR PROLONGED LOSS OF
POWER.
Turn the transmitter OFF, loosen the two thumbscrews on the bottom of the unit and open the unit by
pulling on the belt loop. (See below). Pull out the battery holder until the batteries can be accessed. Do not
pull hard on the battery holder as it is attached to the logic board by a cable. Unsnap the battery cable (for
