Section 6 - Wiring (Continued)
50
TABLE 2(H) TR12 2-SPEED
PROGRAMMING DIAGRAM.
STANDARD 2-SPEED 4 MOTOR SYSTEM
MOTOR 1 CONNECTIONS
MOTOR 2 CONNECTIONS MOTOR
3 CONNECTIONS
J4-3 MAIN
HOIST
UP
J3-3
TROLLEY
DIR 1
J2-3
BRIDGE
DIR 1
J4-2 MAIN
HOIST
2
ND
SPEED
J3-2
TROLLEY
2
ND
SPEED
J2-2
BRIDGE
2
ND
SPEED
J4-1 MAIN
HOIST
DOWN
J3-1
TROLLEY
DIR 2
J2-1
BRIDGE
DIR 2
J4-4 HOT (J4-1, 2 & 3)
J3-4 HOT (J3-1, 2 & 3)
J2-4 HOT (J2-1, 2 & 3)
MOTOR 4 CONNECTIONS
J5-6 AUX
HOIST
UP
J5-5 HOT AUX
HOIST
UP
J5-4 AUX
HOIST
2
ND
SPEED
J5-3 HOT AUX
HOIST
2
ND
SPEED
J5-2 AUX
HOIST
DOWN
J5-1 HOT AUX
HOIST
DOWN
NOTE
CHECK GOVERNMENTAL AND LOCAL REGULATIONS ON THE REQUIREMENTS OF HORNS OR ALARMS
BEFORE USING THIS CONFIGURATION, AS THERE IS NOT A SEPARATE ALARM CONTROL.
TRANSMITTER SWITCH SETTINGS (This configuration does not apply to the Membrane transmitter).
telePilot
USE PDA SCREEN (Program the configuration switches 5, 6 and 7 to OFF. Under “Main/Aux” select the
setting “Motor”).
PENDANT, JLTX AND SLTX TRANSMITTER SWITCH SW4 “D” SETTINGS:
Position-1 Position-2 Position-5
Position -6
Position –7
OFF ON OFF OFF OFF
*NOTE: Hoist, Trolley and Bridge are listed here as traditional configurations, the installer may choose to define the
motors differently.
OUTPUTS
J2-3
J2-2
J2-1
BRIDGE*
MOTOR 3
1
ST
2
ND
Dir 1 Dir 2
OUTPUTS
J4-3
J4-2
J4-1
MAIN HOIST*
MOTOR 1
1
ST
2
ND
UP DN
2
ND
1
ST
2
ND
1
ST
OUTPUTS
J3-3
J3-2
J3-1
TROLLEY*
MOTOR 2
1
ST
2
ND
Dir 1 Dir 2
2
ND
1
ST
OUTPUTS
J5-6
J5-4
J5-2
AUX HOIST*
MOTOR 4
1
ST
2
ND
UP DN
2
ND
1
ST
OFF
1 2 3 4 5 6 7 8
ON
For these switch
positions see
previous section.
Indicates Switch in OFF Position.
