Section 8 – RCP Programming (Continued)
98
check from the box disables the “Both” function (“A” and “B” will not come ON at the same time). This function maps to
Pendant Switch 4 position 3; if SW4 position 3 is switched “ON”, un-check Tandem box.
Invert Crane Select Aux. Outputs. (Two speed only. Normally not checked).
This function appears if a system using select is programmed in. Turning this switch “ON” inverts the select function
operation so that the relay closes for the unselected function. This function maps to Pendant Switch 4 position 4; if SW4
position 4 is switched “ON”, check Invert box. Invert logic is used by many European hoist manufacturers.
Mode selection (One speed only).
This function defines the operating modes for single speed transmitters working with series 9000 receivers.
Series 9000 frequency and access code setting.
Series 9000 frequencies are identified by a letter. Each frequency has a pre-defined access code, using the last four bits.
The first four bits can be set as desired by the customer. Note that transmitter and receiver access code and frequency must
match.
Saving, Downloading, Reading The Programs and Other RCP Software Functions.
NOTE
TO PROGRAM OR READ DATA FROM THE telePilot, THE TRANSMITTER MUST BE TURNED ON.
Saving the Programming File.
Once programming is complete click the file tab at the top of the RCP screen to open the file menu. File location and name
can be selected from this menu. Old files can be deleted, called up, modified and renamed by this same menu.
Sending a Program to the telePilot.
WARNING
AFTER EVERY PROGRAMMING OF THE TRANSMITTER, TEST THE UNIT BY TURNING IT ON AND OFF
NEAR THE APPROPRIATE RECEIVER. IF THE RECEIVER DOES NOT RESPOND, DO NOT ACTIVATE A
FUNCTION BUTTON! THE TRANSMITTER MAY HAVE INCORRECT PROGRAMMING, WHICH COULD MOVE
ANOTHER CRANE. RE-CHECK THE PROGRAMMING IN THE TRANSMITTER AND RETEST. AFTER
ACTIVATION OF RECEIVER, FUNCTIONALLY TEST ALL COMMANDS ON THE TRANSMITTER BY
INITIALLY JOGGING THE BUTTONS, THEN WITH A FULL MOVEMENT BEFORE RETUNING TO SERVICE.
FAILURE TO FOLLOW THIS WARNING COULD RESULT IN SERIOUS INJURY OR DEATH AND DAMAGE TO
EQUIPMENT.
To send a program file, consisting of up to four banks, to a telePilot Transmitter:
1.
Turn transmitter unit ON. Note that the Tx Red LED is flashing.
2.
Line up the IR adaptor with the transmitters infrared port (remove battery door on the back and pull battery pack
back and expose the
telePilot
’s infrared port).
3.
Click the send button on the RCP screen. A dialog box will pop up confirming that you want to proceed. Check
the box marked “I accept” and then click the button “Continue send to radio”. Onscreen prompts will confirm that
the transmitter has been programmed or if there are any issues.
Receiving (Reading) the telePilot Programming.
To read a program file from the
telePilot
Transmitter:
