Magnetek IMPULSE G+ Mini, Technical Manual

Page: 95 / 182

IMPULSE
®
•G+ Mini Technical Manual
November 2020
Page 95
0C Lower Limit 1 N.C. Lower Limit - SLOW DOWN; Normally Closed. LL1
- blinking 67
0D Lower Limit 2 N.C. Lower Limit - STOP; Normally Closed. LL2 -
blinking 67
0E M-Speed Gain 1 Micro-Speed positioning control multiplier 1. Gain is
set by parameter C02.01 (has priority over MS2) 66
0F Not used No function - terminal is disabled -
10 M-Speed Gain 2 Micro-Speed positioning control multiplier 2. Gain is
set by parameter C02.02. 66
12 Weight Limit N.C. Weighted Upper Limit (UL3); Stopping Method
determined by C03.08. 67
13 Swift-Lift Swift-Lift Enable (C06.01 = 2). Not available for
Traverse Motion 72
14 Alt T-Lim Gain Alternate Torque Limit Gain - C07.05. Use when
load testing a hoist 75
15 Forward Jog Uses B01.17 reference 49
16 Reverse Jog Uses B01.17 reference 49
17 Forward Inch Inch Forward 78
18 Reverse Inch Inch Reverse 78
19 Inch Repeat Inch Repeat 78
1A Acc/Dec 2 Acceleration and Deceleration Time Changeover 2
using B05.03 and B05.04 61
1B Acc/Dec 3 Acceleration and Deceleration Time Changeover 3
using B05.12 and B05.13 61
1C Acc/Dec 4 Acceleration and Deceleration Time Changeover 4
using B05.14 and B05.15 61
1D Digital Chngover Analog/Digital Reference Changeover B01.18 = 1
Open = Analog
Closed = Digital
49
1F Opt/Inv Switch Option Reference Selection (Frequency and Run
Reference from Option card. Input On = Option
Card). Set B03.01, B03.02 = Terminals 52
20 thru 2F External
Fault
External Fault selection 97
30 Program Lockout Program Lockout
Closed: Parameters enabled to write
Open: Parameters disabled to write other than freq.
reference (U01.01)
-
31 Local/Remote Sw Closed = Local -
32 Ext BB N.O. N.O.: Baseblock by ON. Immediate stop at STOP
command; normally open -
33 Ext BB N.C. N.C.: Baseblock by OFF. Immediate stop at STOP
command; normally closed -
39 External OH2 VFD overheat prediction (OH2 is shown by ON).
Alarm only. -
Parameter Name Function Page Range Default
* Parameter defaults changed by X-Press Programming