Magnetek IMPULSE G+ Mini, Technical Manual

Page: 49 / 182

IMPULSE
®
•G+ Mini Technical Manual
November 2020
Page 49
5 Programming Features
5.1 Application
The application parameters control the acceleration and deceleration characteristics, as well as any preset
frequencies the system will require for operation. Application parameters included in this section are listed below:
• B1 Speed References
• B2 Reference Limits
• B3 Sequence/Reference Source
• B5 Acceleration/Deceleration
• B8 Jump Frequencies
5.1.1 Speed References
* Initial value is determined by X-Press Programming ( Table 4-1 on page 44 and Table 4-2 on page 45 ).
Parameter Name Function Range Default
B01.01 Reference 1 Sets the Speed 1 frequency. 0.00–150.00 Hz 15.00*
B01.02 Reference 2 Sets the Speed 2 frequency. 0.00–150.00 Hz 30.00*
B01.03 Reference 3 Sets the Speed 3 frequency. 0.00–150.00 Hz 60.00*
B01.04 Reference 4 Sets the Speed 4 frequency. 0.00–150.00 Hz 0.00*
B01.05 Reference 5 Sets the Speed 5 frequency. 0.00–150.00 Hz 0.00*
B01.06 Reference 6 Sets the Speed 6 frequency. 0.00–150.00 Hz 0.00*
B01.07 Reference 7 Sets the Speed 7 frequency. 0.00–150.00 Hz 0.00*
B01.08 Reference 8 Sets the Speed 8 frequency. 0.00–150.00 Hz 0.00*
B01.09 Reference 9 Sets the Speed 9 frequency. 0.00–150.00 Hz 0.00*
B01.10 Reference 10 Sets the Speed 10 frequency. 0.00–150.00 Hz 0.00*
B01.11 Reference 11 Sets the Speed 11 frequency. 0.00–150.00 Hz 0.00*
B01.12 Reference 12 Sets the Speed 12 frequency. 0.00–150.00 Hz 0.00*
B01.13 Reference 13 Sets the Speed 13 frequency. 0.00–150.00 Hz 0.00*
B01.14 Reference 14 Sets the Speed 14 frequency. 0.00–150.00 Hz 0.00*
B01.15 Reference 15 Sets the Speed 15 frequency. 0.00–150.00 Hz 0.00*
B01.16 Reference 16 Sets the Speed 16 frequency. 0.00–150.00 Hz 0.00*
B01.17 Jog Reference Sets the Jog frequency. 0.00–150.00 Hz 6.00*
B01.18 Reference Priority Determines whether the digital or analog
frequency reference is used. 00*
00 Digital Ref Only
01 Analog Ref Only
02 Higher Ref Sel
NOTE: When using Higher Ref Sel, 2-Step
Infinitely Variable should NOT be
used (A01.04 = 03). The two
functions are not intended to work
in conjunction.