Mackie 8-BUS Series, Owner'S Manual

Page: 81 / 247

6-4
D i g i t a l 8 • B u s
Starting a New Session
TO ADJUST THE CHANNEL PAN CONTROL
From the screen:
1. Click on the PAN button below the
MASTER V-Pot. The Master V-Pot be-
comes disabled, and the channel
V-Pots become pan controls.
2. Click and hold on the channel V-Pot,
and move the mouse left and right (or
up and down) to pan the signal to the
left and right. The box below the V-Pot
indicates the pan position numerically,
from zero at center to 127L and 126R.
When an AUX button is pressed in the
V-Pot Select Section, the channel V-Pots
adjust the selected Aux Send level.
Note: The Aux Send function does not ap-
ply to Fader Deck 4. When Fader Deck 3 is
selected, the Aux Sends associated with
each FX Return are locked out to prevent
feedback loops. For example, if Aux 2 is
selected in the V-Pot Select Section, the
Aux Send control on FX 3 and 4 are disabled.
AUX 7 AUX 8
AUX 5
AUX 6
AUX 1
AUX 3
AUX 2
AUX 4
LEVEL TO TAPE
DIGITAL TRIM
1-24 1-48
12
36
SELECT
Adjusting the Aux Send Levels
TO ADJUST THE AUX SEND LEVELS
From the console:
1. Press one of the AUX buttons in the
V-Pot Select Section. The Master
V-Pot becomes the Master Aux Send
Level control for the selected aux bus,
and the channel V-Pots become the
channel aux send Level controls.
2. Rotate the channel V-Pot to the right
to increase the signal in the selected
aux bus, and to the left to reduce the
amount of signal in the selected Aux
bus. The ring of LEDs around the
V-Pot indicates the relative position
setting of the control.