215634
62
Revision B
1034409
A
B
C
D
E
F
G
H
J
L
K
M
N
Figure 3.55: Rear Sliding Hydraulics Connection
NOTE:
The walking beam pivot bracket is transparent in the illustration above to show the barrel end of the right cylinder.
13. Connect the rear end sliding leg hoses from the valve block to the hydraulic cylinders as follows:
a.
Connect the hose from port P8 on the valve block marked with yellow cable tie to the top of tee (A) attached to
the walking beam.
b.
Connect loose hose (B) from the left of tee (A) to the rod end of left cylinder (C).
c.
Remove bolt (D) and attach p-clip (E). Reinstall the bolt, and torque to 40 Nm (32 lbf·ft).
d.
Connect hose (F) from right of tee fitting (A) to the rod end of right cylinder (G).
e.
Remove bolt (H) and attach p-clip (J). Reinstall the bolt, and torque to 40 Nm (32 lbf·ft).
f.
Connect hose (K) from port P7 on the valve block marked with green cable tie to top of tee (L).
g.
Connect short hose (M) draped across the walking beam pivot at tee (L) to barrel end (N) of the right cylinder.
