215634
99
Revision B
3.19
Installing Rear Light Assembly and Optional Ballast Package
Ballast kits are for draper headers only. When operating the windrower with a heavy draper header, ballast needs to be
added to the aft end. Use the following table to determine the amount of ballast required. Depending on ballast
requirements, follow instructions to install rear light assembly with or without ballast package.
Refer to
4.1.14 Checking Tire Pressure, page 132
for proper tire pressures when operating with the applicable header.
NOTE:
A base kit (MD #B6053) contains eight 20.4 kg (45 lb.) weights for a total weight of 163 kg (360 lb.).
Table 3.2 Ballast
Header Type
Description
Installed Options
Base Kit
Additional
Kits
Additional
Float Springs
D125X
25 foot, single reel,
double knife, timed
–
0
0
0
D130XL
30 foot, single reel,
double knife, timed
Transport
1
0
0
D130XL
30 foot, single reel,
double knife, timed
Tra upper cross
auger + vertical knives
1
0
MD #B6047
D135XL
35 foot, single reel,
double knife, untimed
Base
1
0
0
D135XL
35 foot, single reel,
double knife, untimed
Transport
1
0
MD #B6047
D135XL
35 foot, single reel,
double knife, untimed
Tra upper cross
auger + vertical knives
1
0
MD #B6047
D135XL
35 foot, double reel,
double knife, untimed
Base
1
0
0
D135XL
35 foot, double reel,
double knife, untimed
Transport
1
0
MD #B6047
D135XL
35 foot, double reel,
double knife, untimed
Tra upper cross
auger + vertical knives
1
0
MD #B6047
Installing rear light assembly
–
no ballast package required
1034604
A
A
A
B
A
Figure 3.119: Rear Light Bezel Assembly
1.
Remove eight bolts and washers (A) from the rear light
assembly and remove bezel (B).
