215634
53
Revision B
1034357
A
B
C
D
Figure 3.32: Walking Beam Adjuster Plugs
26. Retrieve adjuster plugs (A) with preinstalled wear pads
from the cab. Thread the adjuster plugs into the walking
beam until the wear pads are tight against caster wheel
extension (B).
27. Tighten and torque the adjuster plugs to 340 Nm
(250 lbf·ft).
28. Back off the adjuster plugs by 1/4 of a turn and align the
slot in the adjuster plugs with the anti-rotation holes.
Secure with bolts (C) and nuts (D) as shown.
1034361
A
D
C
B
E
F
G
Figure 3.33: Cylinder Installed
29. Install cylinder (A) as follows:
a.
At the barrel end, secure the cylinder using pin
strap (B), bolt and nut (C), and cylinder pin (D) retained
in Step
.
b.
At the rod end, secure with clevis pin (E) and cotter
pin (F) that is preinstalled on the caster wheel
extension.
30. Move stop bracket (G) back to storage position.
Installing left caster wheel
1026759
A
B
Figure 3.34: Caster Wheels Shipping Assembly
31. Use a suitable lifting device to support the left caster
wheel (A), and remove angle brace (B).
NOTE:
Ensure the wheel is supported; the wheel may shift when
the brace is removed.
