215634
173
Revision B
1015883
A
Figure 5.38: Center-Link
19.
Windrowers with self-aligning center-link:
Release center-
link latch (A) before returning to the cab.
1029799
A
Figure 5.39: Safety Prop Lever
20. Disengage the safety props on both lift cylinders as follows:
a.
Turn lever (A) away from the header to raise the safety
prop until the lever locks into the vertical position.
b.
Repeat the previous step for the opposite cylinder.
NOTE:
If the safety prop will
NOT
disengage, raise the header to
release the prop.
21. Repeat for the opposite side.
DANGER
Ensure that all bystanders have cleared the area.
1019480
A
B
C
Figure 5.40: GSL
22. Start the engine.
23. Remove header float when prompted by the Harvest
Performance Tracker (HPT).
NOTE:
If not prompted by the HPT to remove float, remove float
manually.
24. Lower the header to the ground with HEADER DOWN
switch (A).
25. Press HEADER TILT switches (B) as required on GSL to
release load on center-link.
26.
Windrowers with self-aligning center-link:
a.
Press REEL UP switch (C) to disengage center-link from
header.
b.
Proceed to Step
