215634
49
Revision B
3.5
Installing Caster Wheels
Caster wheels are non-driven wheels mounted at the end of the windrower near the engine.
1034327
B
A
Figure 3.20: Caster Wheels Shipping Assembly
1.
Remove two bolts and nuts (A), and two rear wearplates (B)
from the center support.
NOTE:
The hardware for mounting the rear wearplates to the
walking beam is in a bag, secured to the rear wearplates,
not shown in the illustration.
1034332
A
B
C
E
D
Figure 3.21: Rear Wearplate in Walking Beam
—
Left
Side Shown
2.
Position rear wearplate (A) inside wearplate mount (B) of
walking beam (C) with the grease groove facing away from
the wearplate mount. Secure with bolts (D), and torque to
43 Nm (32 lbf·ft).
NOTE:
Wearplate mount (B) is transparent in the illustration at
right to show the rear wearplate.
3.
Loosely install bolt with zerk (E) into the inboard hole. Do
NOT
torque until the p-clip is installed with hydraulics.
4.
Repeat Step
to Step
at the
opposite side.
1034324
B
B
A
A
C
C
Figure 3.22: Anti-Shimmy Dampener Bracket
5.
Mark shimmy shock mounts (B) and caster wheel
extensions (C) that are on the same side of the
shipping stand.
6.
Remove bolts and nuts (A), and shimmy shock mounts (B)
from the shipping stand. Retain for installation later.
