215634
141
Revision B
1.
Start the engine.
1014874
A
Figure 4.66: HPT Display
2.
Move the throttle to the idle position.
3.
Check engine speed (A) on the Harvest Performance
Tracker (HPT) display and compare it to the value in the
table below.
4.
Move the throttle to the maximum rpm position.
5.
Check engine speed (A) on the HPT and compare it to the
value in the table below.
NOTE:
The engine speed mentioned in the table below assumes
that the Eco Engine Control (EEC) feature is
not active
. For
more information about EEC, refer to the windrower
operator
’
s manual.
Table 4.1 Engine Speed
Idle
Maximum (No Load)
1000 rpm
2300 rpm
6.
Shut down the engine, and remove the key from
the ignition.
4.2.4
Checking Retract and Extend Functions of the Narrow Transport System
The narrow transport feature needs to be checked if the drive wheel legs and walking beam extensions fully extend and
retract.
DANGER
To prevent injury or death from the unexpected start-up of the machine, always stop the engine and remove the key
from the ignition before leaving the operator
’
s seat for any reason.
1.
Ensure the narrow transport function is enabled on the Harvest Performance Tracker (HPT). For instructions, refer to
Enabling Narrow Transport System in the Harvest Performance Tracker, page 139
.
2.
Shut down the engine, and remove the key from the ignition.
1034118
A
B
Figure 4.67: Transport Electrical Connector
3.
Retrieve the transport harness from holder (A), located
behind the left platform, and connect it to electrical
receptacle (B).
