214778
60
Revision A
1021001
A
B
C
D
E
Figure 5.20: Left Side Tension Adjuster Shown
–
Right
Side Opposite
IMPORTANT:
Do
NOT
adjust nut (C). This nut is used for draper
alignment only.
7.
To loosen draper tension, turn adjuster bolt (A)
counterclockwise. The white indicator bar (B) will move
outboard in the direction of arrow (D) to indicate that the
draper is loosening. Loosen until the white indicator bar is
at the halfway point in the window.
8.
To tighten draper tension, turn adjuster bolt (A) clockwise.
The white indicator bar (B) will move inboard in the
direction of arrow (E) to indicate that the draper is
tightening. Tighten until the white indicator bar is at the
halfway point in the window.
IMPORTANT:
To avoid premature failure of the draper, draper rollers,
and/or tightener components, do
NOT
operate if the white
bar is not visible.
IMPORTANT:
To prevent scooping dirt, ensure the draper is tight enough
that it does not sag below the point where the cutterbar
contacts the ground.