214778
25
Revision A
1015796
A
B
Figure 3.21: Header Leg and Draper Header Support
9.
Drive the windrower slowly forward until the draper header
supports (A) enter the header legs (B). Continue driving
slowly forward until lift linkages contact the support plates
in the header legs and the header nudges forward.
10. Ensure that lift linkages are properly engaged in header legs
and are contacting the support plates.
1016903
A
B
C
Figure 3.22: Hydraulic Center-Link
11.
Self-Aligning Hydraulic Center-Link:
a.
Adjust position of the center-link cylinder (A) with the
switches on the GSL until hook (B) is above the header
attachment pin.
IMPORTANT:
Hook release (C) must be down to enable self-locking
mechanism.
b.
If the hook release (C) is open (up), stop the engine and
remove the ignition key. Manually push the hook
release (C) down after the hook engages the header pin.
c.
Lower center-link (A) onto the header with REEL DOWN
switch on the GSL until the center-link locks into position
and the hook release (C) is down.
d.
Check that center-link is locked onto header by pressing the
REEL UP switch on the GSL.