214778
26
Revision A
1016901
A
B
Figure 3.23: Hydraulic Center-Link
12.
Hydraulic Center-Link without Self-Alignment:
a.
Press HEADER TILT UP or HEADER TILT DOWN cylinder
switches on the GSL to extend or retract center-link cylinder
until the hook is aligned with the header attachment pin.
b.
Stop the engine and remove the key.
c.
Push down on rod end of link cylinder (B) until hook
engages and locks onto header pin.
IMPORTANT:
Hook release must be down to enable self-locking
mechanism. If the hook release is open (up), manually push
it down after hook engages pin.
d.
Check that center-link (A) is locked onto header by pulling
upward on rod end (B) of cylinder.
CAUTION
Check to be sure all bystanders have cleared the area.
e.
Start engine.
1014786
A
Figure 3.24: GSL
13. Press the HEADER UP switch (A) to raise header to
maximum height.
14. Stop the engine and remove the key.
1016103
A
Figure 3.25: Cylinder Safety Prop
15. Engage safety prop on the windrower
’
s lift cylinder as
follows:
a.
Pull lever (A) and rotate toward header to release, and
lower safety prop onto cylinder.
b.
Repeat for opposite lift cylinder.
IMPORTANT:
Ensure the safety props engage over the cylinder piston rods. If
safety prop does not engage properly, raise header until prop fits
over the rod.