Chapter 13
| Basic Administration Protocols
Simple Network Management Protocol
– 358 –
Private Traps
swPowerStatusChangeTrap
1.3.6.1.4.1.22426.43.103.2.1.0.1
This trap is sent when the power state changes.
swPortSecurityTrap
1.3.6.1.4.1.22426.43.103.2.1.0.36
This trap is sent when the port is being intruded.
This trap will only be sent when the
portSecActionTrap is enabled.
swIpFilterRejectTrap
1.3.6.1.4.1.22426.43.103.2.1.0.40
This trap is sent when an incorrect IP address is
rejected by the IP Filter.
pethPsePortOnOffNotification
1.3.6.1.4.1.22426.43.103.2.1.0.43
This notification indicates if a PSE port is delivering
power to the PD. This notification should be sent on
every status change except in searching mode.
pethPsePortPowerMaintenanceStatusN
otification
1.3.6.1.4.1.22426.43.103.2.1.0.44
This notification indicates a Port Change Status and
should be sent on every status change.
pethMainPowerUsageOnNotification
1.3.6.1.4.1.22426.43.103.2.1.0.45
This notification indicates PSE threshold usage
indication is on; and the power usage is above the
threshold.
pethMainPowerUsageOffNotification
1.3.6.1.4.1.22426.43.103.2.1.0.46
This notification indicates that the PSE threshold
usage indication is off; and the usage power is
below the threshold.
swAtcBcastStormAlarmFireTrap
1.3.6.1.4.1.22426.43.103.2.1.0.70
When broadcast traffic is detected as a storm, this
trap is fired.
swAtcBcastStormAlarmClearTrap
1.3.6.1.4.1.22426.43.103.2.1.0.71
When a broadcast storm is detected as normal
traffic, this trap is fired.
swAtcBcastStormTcApplyTrap
1.3.6.1.4.1.22426.43.103.2.1.0.72
When ATC is activated, this trap is fired.
swAtcBcastStormTcReleaseTrap
1.3.6.1.4.1.22426.43.103.2.1.0.73
When ATC is released, this trap is fired.
swAtcMcastStormAlarmFireTrap
1.3.6.1.4.1.22426.43.103.2.1.0.74
When multicast traffic is detected as the storm, this
trap is fired.
swAtcMcastStormAlarmClearTrap
1.3.6.1.4.1.22426.43.103.2.1.0.75
When multicast storm is detected as normal traffic,
this trap is fired.
swAtcMcastStormTcApplyTrap
1.3.6.1.4.1.22426.43.103.2.1.0.76
When ATC is activated, this trap is fired.
swAtcMcastStormTcReleaseTrap
1.3.6.1.4.1.22426.43.103.2.1.0.77
When ATC is released, this trap is fired.
stpBpduGuardPortShutdownTrap
1.3.6.1.4.1.22426.43.103.2.1.0.91
This trap will be sent when an interface is shut down
because of BPDU guard.
swLoopbackDetectionTrap
1.3.6.1.4.1.22426.43.103.2.1.0.95
This trap is sent when loopback BPDUs have been
detected.
networkAccessPortLinkDetectionTrap
1.3.6.1.4.1.22426.43.103.2.1.0.96
This trap is sent when a
networkAccessPortLinkDetection event is
triggered.
dot1agCfmMepUpTrap
1.3.6.1.4.1.22426.43.103.2.1.0.97
This trap is sent when a new remote MEP is
discovered.
dot1agCfmMepDownTrap
1.3.6.1.4.1.22426.43.103.2.1.0.98
This trap is sent when port status or interface status
TLV received from remote MEP indicates it is not up.
dot1agCfmConfigFailTrap
1.3.6.1.4.1.22426.43.103.2.1.0.99
This trap is sent when a MEP receives a CCM with
MPID which already exists on the same MA in this
switch.
Table 28: Supported Notification Messages
(Continued)
Model
Level
Group
Summary of Contents for GEL-1061
