Lauda PROLINE Edition X P 12 C, Operating Instructions Manual

Page: 76 / 116

Proline Edition X heating thermostats
76
Starting up
YACE0099 / 10/9/2018
Command
Control Parameters

Open the device parameter menu via the
soft key Menu .

With the cursor keys continue to:

Control

Control Parameters

Control Parameters .

The adjacent window appears.
Parameter endings:
e = Master controller, f = Slave controller.

Where applicable change parameters
marked with (auto) to manual input with
Tv manual/auto .

Select the parameters to be changed with
and confirm with .

Then change the value in the following
settings window and confirm with .

Correction limitation see introduction (

7.13.2).
Proven settings for control parameters and pump (external control):
External consumer
Master controller
(External controller)
Slave controller
(Internal control-
ler)
Device
type
Heat
trans-
fer
liquid
Field of applica-
tion
Volume
[L]
Hose
length
[m]
Kpe
EP
Tne
En
Tve
Eu
Tde
Ed
Prop_E
Eb
Xpf
iP
Pump
level
P 8 Water
Double wall glass vessel
2.5 2x1 2.0 80 60 5.0 30 4.0 5
P 8 Water
Double wall glass vessel
2.5 2x1 2.0 150 130 5.0 30 3.0 5
P 8 Water
Double wall stainless
steel vessel with water
0.7 2x1 0.5 70 50 5.0 30 3.0 5
Steps for setting the control parameters for external control
1. Activate external control (

7.7.4).
2. Setting the slave controller:
2.1. Set parameters to auto ; Xpf see table (

0) (empirical value) in dependence upon:

Check for thermostat type and change when necessary (P....) (

9.2.1).

Choose heat transfer liquid with low viscosity and high thermal capacity.
Ranking: Water, ethanol, water-glycol, oil, Fluorinert®,

set pump level as high as possible,

make bath circulation strong and fast,

choose hose length as short as possible, i.e. 2 x 1m,

choose hose cross section as large as possible, i.e. ½ inch,
Pump Menu End T
set
T
fix
Control Parameters
Control parameter sets
Tv manual/auto
Correction limitation
Kpe 0,50
Tne 100
Tve (auto) 83
Tde (auto)
8,3
Xpf 4,0
Prop_E (a) 30