Installation
27
3. See Figure 2-4. Using the 4mm hex wrench, remove three
M5X15 screws from each plastic inner handrail cover and
remove the covers. Remove the six M8X15 screws on each
side using 6mm hex wrench. Slide the handrails over the
side brackets and secure them in place with six M8x15
socket head cap screws on each side.
Figure 2-4. Handrail Installation
4. Install the inner handrail covers on both sides and use the
4mm hex wrench to secure each cover with three M5x15
socket head cap screws.
5. Remove the four M6X16 button head screws from the bag
stapled to the console box. Thread the ribbon cable and
pulse cable from the lower control panel up through the
center notch in the plastic bridge, then place the plastic
bridge over the handrails and secure using 5mm hex
wrench as shown in Figure 2-5 (four screws from top).
Note:
Ensure that the ribbon cable and pulse cable from the
lower control panel go through the center notch on top of
the bridge, so you can thread them through the upright in
Step 7.
Both Sides
M8X15 (6x)
Socket Head
Cap Screw
M5X15 (3x)
Socket Head
Cap Screw
Handrail
Cover
