KYMCO ADG5, Manual

Page: 365 / 426

10..Brake System
XCITING S 400
ABS Indicator Light Is Unlit (When The Ignition Switch
Turned To ON)
1st step test.
Disconnect the meter connector.
Check the terminal voltage between the ABS signal wire (Pink lead) terminal of
the meter connector and ground. Turn the ignition switch ON.
Terminal Voltage
Standard: About 8V
If the terminal voltage correct, replace the meter assembly.
2nd step test.
Disconnect the meter connector.
Check for continuity between the ABS signal wire (Pink lead) terminal of the main
harness side connector and ground.
If there is the continuity in the lead, replace or repair the main harness.
3rd step test.
Disconnect the ABS hydraulic unit connector.
Check for continuity between the ABS signal wire (Pink lead) terminal of the
meter side connector and the ABS signal wire (Pink lead) terminal of the ABS unit
side connector.
If there is the continuity in the lead, replace the ABS hydraulic unit.
If there is not the continuity in the lead, replace or repair the main harness.
10-28