Powering Operations for the 990-HQ
2-25
990-HQ Operation Manual
Home the 990-HQ
After Start up the Machine Feedbacks on all machines will display
“Machine Ready”.
After this
message is displayed the machine is ready to Home
The 990-HQ must go through a homing routine before any operations are performed. The homing
routine sets a zero reference from which the 990-HQ measures its movement and cutting process.
If power is lost or the 990-HQ is re-set, the homing routine must be performed again to reset the
zero reference
Press the
Home Machine
button on the
Main Screen
touch screen.
1.
The machine will move to the home position at the
in-feed end of the machine.
2.
The machine will then move to about the middle of
it’s travel.
The 990-HQ is now ready for work.
How to Power Down the 990-HQ
1.
1
2
3
Select
Shut Down System
from the
Main Screen
to close
operator interface program and shut down the operating
system.
Note:
Make sure Windows is shutdown completely before
turning off the machine.Hard drive or data may be
damaged if not turned off in this order.
2.
Select
Shut Down System
from the
Main Screen
to close
operator interface program.
3.
KVAL also recommends that you turn the disconnect
switch on the electrical cabinet to OFF; this helps reduce
possible damage resulting from power surges from electri-
cal storms.
