About the Operator Station and Front Section Controls
2-5
990-HQ Operation Manual
About the Foot Pedal and Control Box
The control box is located near the center eight shooter on the front section of the machine.
Includes manual controls of the Jamb Clamp, RH or LH orientation, and eight shooter operation.
Door Clamp Pedal
: The door clamp pedal activates the door clamp to either
clamp or unclamp the door. Can be used in manual mode to position a door.
Press once to clamp, press again to unclamp.
Jamb Clamp Pedal:
The jamb clamp pedal activates the jamb clamps to
clamp the jamb in place. or to unclamp a jamb. Press once to clamp, press
again to unclamp.
See “Powering Operations for the 990-HQ” on page 2-24.
Door Clamp / Un-Clamp
Jamb Clamp / Un-Clamp
Foot Pedal
Control Box
Control Box
Start Sequence:
Press to start the door sequence that was pre-selected by
the operator via the touch-screens. Push when jamb is loaded and clamped
properly, hinges have been loaded, and hands are safely out of the way.
Note:
Be prepared for the front section routers to move into position and
begin routing, as well as the back section routers, lock bore, and bolt drill.
The Eight-Shooter heads will also begin to move into position.
Door Auto RH / LH:
Select to receive either a left-hand or right-hand incom-
ing door.
Unclamp:
Use this button when performing a manual door run to unclamp the
door after machining is complete. If you are performing an auto run and have
activated the “Auto Unclamp” button on the auto run touchscreen, then press-
ing “Unclamp” button is not necessary.
Emergency Stop:
The red emergency stop button halts machine operation; it
does not kill electrical power in the machine.
Important:
If, at any time, the operator must work on or enter the machine for
any reason, shut off electrical power and properly lock and tag-out the machine
to remove electrical energy from the machine. If a problem occurs during oper-
ation, push the emergency stop button.
Pause Auto UnClamp:
If the auto-clamp function is activated, select this but-
ton to pause the auto unclamping routine. Use this function to inspect the door
in process.
