Kubota M108S, Workshop Manual

Page: 77 / 523

G-60
M108S, WSM G GENERAL
NOTE
■
• The following special tools are not provided, so make them referring to the figure.
Draft Control Test Bar
Application: Use for checking the lift range and floating range of
hydraulic draft control.
W10625190
Hydraulic Arm Shaft Bushing Press-Fitting Tool
Application : Use for replacing the hydraulic arm shaft bushings in
the hydraulic cylinder body.
W10316550
A 1045 mm (41.14 in.)
B 1000 mm (29.37 in.)
C 20.0 mm dia. (0.787 in. dia.)
D 30.0 mm dia. (1.18 in. dia.)
E 90.0 mm (3.54 in.)
F 36.5 mm (1.44 in.) (Top link mounting hole)
G 30.0 mm (1.18 in.)
H 15.0 mm (0.591 in.)
I 26.0 mm dia. (1.02 in. dia.)
J Weld all around
K Weld all around
L 20.0 mm (0.787 in.)
Right Left
A
64.75 to 64.95 mm
(2.550 to 2.557 in.) 69.75 to 69.95 mm
(2.746 to 2.753 in.)
B
17.5 to 18.5 mm
(0.689 to 0.728 in.) 13.5 to 14.5 mm
(0.532 to 0.570 in.)
C 60.0 mm (2.36 in.)
D 32.0 mm (1.26 in.) 40.0 mm (1.57 in.)
E
59.970 to 59.999 mm
(2.3611 to 2.3621 in.) 64.970 to 64.990 mm
(2.5579 to 2.5586 in.)
F 70.0 mm dia. (2.76 in. dia.)
G 40.0 mm dia. (1.57 in. dia.)
H 50.0 mm (1.97 in.)
I 10.0 mm (0.397 in.)
a 6.3
μ
m (250
μ
in.)
b 6.3
μ
m (250
μ
in.)
c 6.3
μ
m (250
μ
in.)
d 6.3
μ
m (250
μ
in.)
KiSC issued 06, 2007 A