Kubota M108S, Workshop Manual

Page: 343 / 523

6-S7
M108S, WSM FRONT AXLE
Draining Front Axle Gear Case Oil
1. To drain the used oil, remove the right and left drain plugs (2) and
filling plugs (1) at the front axle gear case and drain the oil
completely into the oil pan.
2. After draining reinstall the drain plugs (2).
3. Fill with the new oil up to the filling plug port.
Refer to “4. LUBRICANTS, FUEL AND COOLANT” at “G.
GENERAL” section.
4. After filling, reinstall the filling plugs (1).
W1013799
Propeller Shaft
1. Slide the propeller shaft cover (3) after removing the screw (5).
2. Tap out the spring pins (2) and then slide the coupling (1) to the
rear.
(When reassembling)
• Apply grease to the splines of the propeller shaft (6) and pinion
shaft.
• Tap in the spring pins (2) as shown in figure.
W1019695
Front Axle Gear Case
Oil
Capacity
3.5 L
3.7 U.S.qts.
3.1 Imp.qts.
for each side
(1) Filling Plug (2) Drain Plug
(1) Coupling
(2) Spring Pin
(3) Propeller Shaft Cover
(4) Spring Pin (5) Screw
(6) Propeller Shaft
(7) Coupling
KiSC issued 06, 2007 A