Kubota M108S, Workshop Manual

Page: 444 / 523

9-S20
M108S, WSM ELECTRICAL SYSTEM
Entering Traveling Speed Coefficient
[Example : Entering 4953 mm]
1. While pressing the traveling speed select switch (2), turn the key
switch to “ON” position. The setting of the current tire’s
circumference is displayed in inches or millimeters. The highest-
digit numeral starts flashing.
2. Each time both the PTO/Hour meter select switch (1) and
traveling speed select switch (2) are pressed at the same time,
the unit changes for inches or millimeters. Select the inch display
mode.
3. Note that the highest-digit numeral is flashing. Press the PTO/
Hour meter select switch (1) to select “4”. (The numeral
changes from 0 to 9 at each push of the switch.)
4. Press the traveling speed select switch (2), and the next highest
digit starts flashing. Now press the PTO/Hour meter select
switch (1) to select “9”.
5. Enter “5” and “3” for the remaining digits in the same procedure.
6. Make sure the entry is “4953”. Press and hold the traveling
speed select switch (2) longer than 2 seconds. The setting is put
in memory, and the LCD monitor (3) goes back to the hour meter
mode.
7. Turn the key switch to “OFF” position to exit.
NOTE
■
• The setting will be cancelled if the key switch is turned OFF
halfway in the procedure.
Tire circumference chart (reference)
W1022482
Rear tire size Entry (in.) Entry (mm)
18.4-34 194 4928
18.4R34 195 4953
16.9-34 187 4750
18.4-30 183 4648
18.4R30 182 4623
(1) PTO/Hour Meter Select Switch
(2) Traveling Speed Select Switch
(3) LCD Monitor (A) Procedure to enter the traveling
speed coefficient mode
(B) Procedure to select display for
inches or millimeters
(C) Procedure to select numerical at
highest digit
(D) Procedure to change next highest
digit and select numerical
(E) Procedure to put in memory
KiSC issued 06, 2007 A