Kubota M108S, Workshop Manual

Page: 43 / 523

G-26
M108S, WSM G GENERAL
Draining Fuel Tank Water
1. Remove the drain plug (2) at the bottom of the fuel tank (1) to left
sediments, impurities and water out of the tank.
2. Finally attach the drain plug (2) on the fuel tank (1).
(When reassembling)
IMPORTANT
■
• If the fuel contains poor qualities with much water in it, drain
the fuel tank at shorter intervals.
• Drain the fuel before operating the tractor after a long period
of storage.
W1046897
Adjusting Toe-in
1. Park tractor on a flat place.
2. Turn steering wheel so that front wheels are in the straight ahead
position.
3. Lower the implement, lock the park brake and stop the engine.
4. Measure distance between tire beads at front of tire, hub height.
5. Measure distance between tire beads at rear of tire, hub height.
6. Front distance should be shorter than rear distance.
7. If not, adjust tie-rod length.
■
Toe-in Adjustment
1. Detach the snap ring (1).
2. Loosen the tie-rod joint lock nut (3).
3. Turn the tie-rod joint (2) to adjust the rod length until the proper
toe-in measurement is obtained.
4. Retighten the tie-rod joint lock nut (3).
5. Attach the snap ring (1) of the tie-rod joint.
W1047149
Checking Intake Air Line
1. Check to see that hoses and hose clamps are tight and not
damaged.
2. If hoses and clamps are found worn or damaged, replace or
repair them at once.
W1033756
(1) Fuel Tank (2) Drain Plug
Toe-in (b-a)
Factory
spec.
4WD
2.0 to 8.0 mm
0.079 to 0.31 in.
Tightening torque Tie-rod joint lock nut
167 to 196 N·m
17.0 to 20.0 kgf·m
123 to 144 lbf·ft
(1) Snap Ring
(2) Tie-rod Joint
(3) Tie-rod Joint Lock Nut (a) Wheel-to-wheel distance at front
(b) Wheel-to-wheel distance at rear
(c) Front
(1) Hose (2) Hose Clamp
KiSC issued 06, 2007 A