Kubota M108S, Workshop Manual

Page: 521 / 523

10-S46
M108S, WSM CABIN
Before Replacing Windshields (3)
1. Check that the glasses are not damaged and cracked.
2. Turn over the glass and clean this surface of the glass by Sika-
cleaner No. 1.
3. The cleaning area of the rear surface is indicated “A” in the
figure left.
NOTE
■
• If not cleaning the glass, it may result in adhesive failure.
W1035931
(7) Wiper Motor
Front Wiper Motor
1. Remove the steering wheel and steering post under covers.
2. Remove the meter panel.
3. Remove the panel under cover.
4. Disconnect the front wiper motor 4P connector (2).
5. Remove the wiper arm mounting nut (4) and wiper arm (5).
6. Remove the wiper link cap (3).
7. Disconnect the earth lead setting screw.
8. Remove the front wiper motor bracket (7) mounting screw (8),
then take out the front wiper motor (1).
(When reassembling)
W1031321
(1) Upper Windshield
(2) Lower Windshield (Left)
(3) Lower Windshield (Right) A : 25 mm (1.0 in.)
Tightening torque Wiper arm mounting nut
6.37 to 9.32 N·m
0.65 to 0.95 kgf·m
4.7 to 6.9 lbf·ft
(1) Front Wiper Motor
(2) Front Wiper Motor Connector 4P
(3) Wiper Link Cap
(4) Nut
(5) Wiper Arm (6) Wiper Blade
(7) Wiper Motor Mounting Bracket
(8) Wiper Motor Bracket Mounting
Screw
(9) Ground Wire Mounting Screw
KiSC issued 06, 2007 A