Kubota M108S, Workshop Manual

Page: 49 / 523

G-32
M108S, WSM G GENERAL
Adjusting King-pin Pivot
1. Jack up the tractor, then loosen the lock nut (2).
2. Measure the adjusting screw tightening torque.
3. If tightening torque is not within the factory specifications, adjust
the adjusting screw (1).
4. After adjustment, tighten the lock nut (2) firmly.
W1051354
[9] CHECK POINT OF EVERY 800 HOURS
Adjusting Engine Valve Clearance
1. Refer to “[1] [2] CHECKING AND ADJUSTING” at “1. ENGINE”
section.
W1052150
[10] CHECK POINT EVERY 1500 HOURS
Checking Fuel Injection Nozzule (Active Test)
1. Refer to “Diagnosis Manual”.
W1039924
[11] CHECK POINTS EVERY 3000 HOURS
Checking Turbo Charger
1. Refer to “[1] [2] CHECKING AND ADJUSTING” at “1. ENGINE”
section.
W1034650
Checking Supply Pump
1. Refer to “Diagnosis Manual”.
W1039985
Checking Intake Air Heater
1. Refer to “[4] CHECKING AND ADJUSTING” at “9.
ELECTRICAL SYSTEM” section.
W1034786
Tightening torque
Adjusting screw
5.0 to 9.8 N·m
0.50 to 1.0 kgf·m
3.7 to 7.2 lbf·ft
Lock nut
98.1 to 147.0 N·m
10.0 to 15.0 kgf·m
72.4 to 108 lbf·ft
(1) Screw (2) Lock Nut
KiSC issued 06, 2007 A