Kubota M108S, Workshop Manual

Page: 47 / 523

G-30
M108S, WSM G GENERAL
[7] CHECK POINTS OF EVERY 400 HOURS
Cleaning Water Separator
1. Close the fuel cock (1).
2. Unscrew the retainer ring (2) and remove the cup (3), and rinse
the inside with kerosene.
3. Take out the element and dip it in the kerosene to rinse.
4. After cleaning, reassemble the water separator, keeping out dust
and dirt.
5. Bleed the fuel system. (Refer to “[14] OTHERS” in this section.)
W1049718
Replacing Fuel Filter
1. Remove the fuel filter (1).
2. Put a film of clean fuel on rubber seal of new filter.
3. Tighten the filter until it contacts the mounting surface. Tighten
filter by hand an additional 1/2 turn only.
4. Bleed the fuel system. (Refer to “[14] OTHERS” in this section.)
W1050132
[8] CHECK POINTS OF EVERY 600 HOURS
Replacing Engine Oil Filter
1. Refer to “[2] CHECK POINTS OF INITIAL 50 HOURS” in this
section.
W1050294
Changing Transmission Fluid
1. Refer to “[2] CHECK POINTS OF INITIAL 50 HOURS” in this
section.
W1050340
Changing Front Differential Case Oil
1. Refer to “[2] CHECK POINTS OF INITIAL 50 HOURS” in this
section.
W1050385
Changing Front Axle Gear Case Oil
1. Refer to “[2] CHECK POINTS OF INITIAL 50 HOURS” in this
section.
W1050430
(1) Fuel Cock
(2) Retainer Ring
(3) Cup
(4) O-ring
(5) Element (6) Spring
(7) Red Float
A : CLOSE
(1) Fuel Filter
KiSC issued 06, 2007 A