Kubota M108S, Workshop Manual

Page: 260 / 523

3-S14
M108S, WSM TRANSMISSION
5. DISASSEMBLING AND ASSEMBLING
[1] SEPARATING EACH BLOCK (CLUTCH HOUSING CASE AND
TRANSMISSION CASE)
Draining Transmission Fluid
1. Place oil pan underneath the transmission case.
2. Remove the drain plugs (1).
3. Drain the transmission fluid.
4. Reinstall the drain plugs (1).
(When reassembling)
• Fill up from filling port (2) after removing the filling plug up to the
upper notch on the dipstick (3).
• After running the engine for few minutes, stop it and check the
fluid level again, add the fluid to prescribed level if it is not correct
level.
IMPORTANT
■
• Use only KUBOTA SUPER UDT fluid. Use of other oil may
damage the transmission or hydraulic system.
• Refer to “LUBRICANTS, FUEL AND COOLANT” at “G.
GENERAL” section.
• Do not mixed different brands fluid together.
W1011383
Draining Fuel
1. Place oil pans under the right side fuel tank.
2. Remove the drain cover (2) at the bottom of side fuel tank (1).
3. Drain the fuel.
4. Reinstall the drain cover (2) on the fuel tank (1).
(When reassembling)
• Be sure to fix the O-ring (3) is in position on the drain cover (2).
W1028925
Separating Cabin from Tractor Body
1. Refer to “[2] DISASSEMBLING AND ASSEMBLING” at “10.
CABIN” section.
2. Check the clutch housing case and transmission case are
securely mounted on the disassembling stands.
3. Remove the rear wheels.
(When reassembling)
W1029089
Capacity Transmission fluid
60.0 L
63.4 U.S.qts.
52.7 Imp.qts.
(1) Drain Plug
(2) Dipstick
(3) Filling Port A : Oil level is acceptable with this
range.
Fuel Tank Capacity
175 L
46.2 U.S.gals
38.4 Imp.gals
(1) Fuel Tank
(2) Drain Cover (3) O-ring
(4) Screw
Tightening torque Rear wheel mounting nut
344 to 402 N·m
35 to 41 kgf·m
254 to 296 lbf·ft
KiSC issued 06, 2007 A