Kubota M108S, Workshop Manual

Page: 33 / 523

G-16
M108S, WSM G GENERAL
Changing Transmission Fluid
CAUTION
• Allow engine to cool down sufficiently, oil can be hot and
can burn.
1. To drain the used oil, remove the drain plug (1) at the bottom of
the transmission case and drain the oil completely into the oil
pan.
2. After draining reinstall the drain plug.
3. Fill with the new KUBOTA SUPER UDT fluid up to the upper
notch on the dipstick (2).
Refer to “4. LUBRICANTS, FUEL AND COOLANT” in this
section.
4. After running the engine for a few minutes, stop it and check the
oil level again; add oil to prescribed level.
W1040339
Replacing Hydraulic Oil Filter
CAUTION
• Allow engine to cool down sufficiently, oil can be hot and
can burn.
1. Remove the two oil filters (1).
2. Clean off metal filings with clean rags at the magnetic filters (2).
3. Put a film of clean transmission oil on rubber seal of new filters.
4. Tighten the filter quickly until it contacts the mounting surface.
Tighten filter by hand an additional 1/2 turn only.
5. After the new filter has been replaced, the transmission fluid level
with decrease a little. Make sure that the transmission fluid does
not leak through the seal, and check the fluid level.
Top up if necessary.
IMPORTANT
■
• To prevent serious damage to the hydraulic system, use
only a KUBOTA genuine filter.
W1040732
Transmission fluid Capacity
60.0 L
63.4 U.S.qts
52.7 Imp.qts
(1) Drain Plug
(2) Dipstick
(3) Oil Inlet (A) Oil level is acceptable within the
range.
(1) Hydraulic Oil Filter
(2) Magnetic Filter
(3) Dipstick
(4) Oil Inlet (A) Oil level is acceptable within the
range.
KiSC issued 06, 2007 A