Kubota M105S, Workshop Manual

Page: 54 / 561

G-39
M105S, WSM G GENERAL
Bleeding Brake System
NOTE
■
• While bleeding, make sure to keep enough brake oil in the
brake oil reservoir.
1. Disconnect the brake pipes (1) from the master cylinder.
2. Move the brake pedal up and down by hand. At this time, when
raising the pedal, close the master cylinder outlet by a finger, and
when lowering, release the finger.
Repeat this operation several times. (Prepare and oil can.)
3. After bleeding the master cylinder, install the front brake pipes.
4. After installing the vinyl pipe (3) to the bleeder (2) loosen the
bleeder two turns.
5. Move the brake pedal up and down.
Repeat this motion until air bubble in brake oil disappears.
After bleeding, tighten the bleeders firmly.
(Reference : Importance of Bleeding)
• If the air mixes in the brake hydraulic circuit, poor or no braking
force is obtained due to compress the air even when the brake
pedal is pressed.
Accordingly whenever the hydraulic brake system is
disassembled, be sure to bleed after reassembling.
W1055717
Replacing Light Bulb
1. Head lights.
Take the bulb out of the light body and replcwith a new one.
2. Other lights
Detach the lens and replace the bulb.
W1056015
Tightening torque Brake pipe nut
16.0 to 24.0 N·m
1.6 to 2.5 kgf·m
11.8 to 17.7 ft-lbs
(1) Brake Pipe
(2) Bleeder (on Brake Case) (3) Vinyl Pipe
Light Capacity
Head Lights 60 / 55 W
Tail Light 10 W
Turn Signal / Hazard Light (Front) 21 W
Turn Signal / Hazard Light (Rear) 21 W
Brake Stop Light 21 W
Instrument Panel Light 3.4 W
Work Light 55 W
Dome Light (Room Lamp) 10 W
Sidemarker Light 10 W
Number Plate Light 10 W
KiSC issued 03, 2007 A