Kubota M105S, Workshop Manual

Page: 139 / 561

1-S22
M105S, WSM ENGINE
Air Condenser and Compressor
■
Without discharging the refrigerant from system
1. Remove the air condenser slide stopper (1) and slide out the air
condenser (2).
2. Remove the compressor (3) with hoses.
(When reassembling)
• Take care not to damage the air condenser fin.
• After reassembling the compressor, be sure to adjust the air
conditioner belt tension.
(Refer to “Adjusting Air Conditioner Belt Tension” : See page G-
29.)
■
With discharge the refrigerant from system
1. Refer to “Discharge the Refrigerant” (See page 10-S19).
(When reassembling)
• Charge the refrigerator to the air conditioner system, refer to
“Charging the Refrigerant”. (See page 10-S21.)
2. Disconnect the low pressure hose (5) and high pressure hose (4)
from compressor (3).
3. Disconnect the high pressure hose (6) from receiver.
(When reassembling)
• Apply compressor oil (DENSO CO. ND-OIL8) to the O-rings and
take care not to damage them.
W1033120
Front Axle Support as a Unit
1. Check the front axle and clutch housing case are securely
mounted on the disassembling stands.
2. Install the front axle rocking restrictor (1) (See page G-72) to the
front axle bracket.
3. Separate the front axle support as a unit after removing the front
axle support mounting screws.
(When reassembling)
W1033876
Tightening torque
High pressure hose
retaining nut
11.8 to 14.7 N·m
1.2 to 1.5 kgf·m
8.7 to 10.8 ft-lbs
Low pressure hose
mounting screw
7.8 to 11.8 N·m
0.8 to 1.2 kgf·m
5.8 to 8.7 ft-lbs
(1) Condenser Slide Stopper
(2) Condenser
(3) Compressor (4) High Pressure Hose
(5) Low Pressure Hose
(6) High Pressure Hose
Tightening torque
Front axle support
mounting screw
(M14, UBS) 166.7 to 196.1 N·m
17.0 to 20.0 kgf·m
123.0 to 144.7 ft-lbs
(1) Front Axle Rocking Restrictor
KiSC issued 03, 2007 A