Kubota M105S, Workshop Manual

Page: 145 / 561

1-S28
M105S, WSM ENGINE
(5) Cylinder Head and Valves
Cylinder Head Cover and Nozzle Holder
1. Remove the injection pipes (1).
2. Remove the cylinder head cover (2).
3. Remove the overflow pipe (3).
4. Remove the nozzle holder clamps (4), nozzle holder assembly
(5) and nozzle gaskets.
(When reassembling)
• Check to see that the cylinder head cover gasket is not defective.
• Be sure to place the nozzle gaskets.
• Tighten the head cover mounting bolts to specified torque.
• Mount the check valve with the
↓
mark toward the tank.
W1037062
Tightening torque
Nozzle holder clamp nut
17.7 to 20.6 N·m
1.8 to 2.1 kgf·m
13.0 to 15.2 ft-lbs
Overflow pipe assembly
retaining screw
9.8 to 11.3 N·m
1.0 to 1.15 kgf·m
7.23 to 8.32 ft-lbs
Cylinder head cover screw
6.9 to 11.3 N·m
0.7 to 1.15 kgf·m
5.1 to 8.32 ft-lbs
Injection pipe retaining nut
19.6 to 24.5 N·m
2.0 to 2.5 kgf·m
14.5 to 18.1 ft-lbs
(1) Injection Pipe
(2) Head Cover
(3) Overflow Pipe (4) Nozzle Holder Clamps
(5) Nozzle Holder Assembly
KiSC issued 03, 2007 A