Kubota M105S, Workshop Manual

Page: 136 / 561

1-S19
M105S, WSM ENGINE
[2] DISASSEMBLING AND ASSEMBLING
(1) Separating Front Axle Support as a Unit
Draining Coolant
CAUTION
• Never remove the radiator cap until coolant temperature is
well below its boiling point. Then loosen cap slightly to the
stop to relieve any excess pressure before removing cap
completely.
1. Stop the engine and let cool down.
2. To drain the coolant, open the radiator drain plug (1). When
opening the drain plug set the hose to drain port (2).
3. Remove the radiator cap to completely drain the coolant.
4. After all coolant is drained, reinstall the radiator drain plug.
W1030568
Draining Engine Oil
1. Start and warm up the engine for approx. 5 minutes.
2. Place an oil pan underneath the engine.
3. Remove the drain plugs (1) to drain oil.
4. After draining, screw in the drain plugs (1).
(When reassembling)
• Fill the engine oil up to the upper line on the dipstick (3).
IMPORTANT
■
• Never mix two different type of oil.
• Use the proper SAE Engine Oil according to ambient
temperature.
Refer to “LUBRICANTS, FUEL AND COOLANT”. (See page
G-8.)
W1030778
Coolant Capacity
9.1 L
9.6 U.S.qts
8.0 Imp.qts
(1) Drain Plug (2) Drain Port
Engine Oil Capacity
10.7 L
11.3 U.S.qts
9.4 Imp.qts
(1) Drain Plug
(2) Oil Inlet Plug
(3) Dipstick (A) Oil level is acceptable within this
range.
KiSC issued 03, 2007 A