Kubota M105S, Workshop Manual

Page: 546 / 561

10-S37
M105S, WSM CABIN
Preparation 3
■
Without discharging the refrigerant from system
1. Remove the air condenser slide stopper (1) and slide out the
condenser (2).
2. Remove the compressor (3) with hoses.
(When reassembling)
• Take care not damage the air condenser fin.
• After reassembling the compressor, be sure to adjust the air
conditioner belt tension.
(Refer to “Adjusting Air Conditioner Belt Tension” : See page G-
29.)
■
With discharge the refrigerant from system
1. Refer to “Discharging the Refrigerant” (See page 10-S19).
(When reassembling)
• Charge the refrigerator to the air conditioner system, refer to
“Charging the Refrigerant”. (See page 10-S21.)
2. Disconnect the low pressure hose (5) and high pressure hose (4)
from compressor (3).
3. Disconnect the high pressure hose (6) from receiver.
(When reassembling)
• Apply compressor oil (DENSO CO. ND-OIL8) to the O-rings and
take care not to damage them.
W1052713
Tightening torque
High pressure hose
retaining nut
11.8 to 14.7 N·m
1.2 to 1.5 kgf·m
8.7 to 10.8 ft-lbs
Low pressure pipe
mounting screw
7.8 to 11.8 N·m
0.8 to 1.2 kgf·m
5.8 to 8.7 ft-lbs
(1) Condenser Slide Stopper
(2) Condenser
(3) Compressor
(4) High Pressure Hose (5) Low Pressure Hose
(6) High Pressure Hose
[A] Without discharging the
refrigerant
KiSC issued 03, 2007 A