Kubota M105S, Workshop Manual

Page: 41 / 561

G-26
M105S, WSM G GENERAL
Draining Fuel Tank Water
1. Remove the drain cover (2) at the bottom of right side fuel tank
(1) to left sediments, impurities and water out of the tank.
2. Finally attach the drain cover (2) on the fuel tank (1).
(When reassembling)
• Be sure to fix the O-ring (3) is in position on the drain cover (2).
IMPORTANT
■
• If the fuel contains poor qualities with much water in it, drain
the fuel tank at shorter intervals.
• Drain the fuel before operating the tractor after a long period
of storage.
W1046897
Adjusting Toe-in
1. Park tractor on a flat place.
2. Turn steering wheel so that front wheels are in the straight ahead
position.
3. Lower the implement, lock the park brake and stop the engine.
4. Measure distance between tire beads at front of tire, hub height.
5. Measure distance between tire beads at rear of tire, hub height.
6. Front distance should be shorter than rear distance.
7. If not, adjust tie-rod length.
■
Toe-in Adjustment
1. Detach the snap ring (1).
2. Loosen the tie-rod joint lock nut (3).
3. Turn the tie-rod joint (2) to adjust the rod length until the proper
toe-in measurement is obtained.
4. Retighten the tie-rod joint lock nut (3).
5. Attach the snap ring (1) of the tie-rod joint.
W1047149
Tightening torque
Drain cover mounting
screw
23.6 to 27.4 N·m
2.4 to 2.8 kgf·m
17.4 to 20.2 ft-lbs
(1) Fuel Tank
(2) Drain Cover (3) O-ring
(4) Screw
Toe-in (b-a) Factory spec.
2.0 to 8.0 mm
0.08 to 0.31 in.
Tightening torque Tie-rod joint lock nut
166.7 to 196.1 N·m
17.0 to 20.0 kgf·m
123.0 to 144.7 ft-lbs
(1) Snap Ring
(2) Tie-rod Joint
(3) Tie-rod Joint Lock Nut (a) Wheel-to-wheel distance at front
(b) Wheel-to-wheel distance at rear
(c) Front
KiSC issued 03, 2007 A