Kubota M105S, Workshop Manual

Page: 207 / 561

2-S10
M105S, WSM CLUTCH
Air Condenser and Compressor
■
Without discharging the refrigerant from system
1. Remove the air condenser slide stopper (1) and slide out the air
condenser (2).
2. Remove the compressor (3) with hoses.
(When reassembling)
• Take care not to damage the air condenser fin.
• After reassembling the compressor, be sure to adjust the air
conditioner belt tension.
(Refer to “Adjusting Air Conditioner Belt Tension” : See page G-
29.)
■
With discharge the refrigerant from system
1. Refer to “Discharge the Refrigerant” (See page 10-S19).
(When reassembling)
• Charge the refrigerator to the air conditioner system, refer to
“Charging the Refrigerant”. (See page 10-S21.)
2. Disconnect the low pressure hose (5) and high pressure hose (4)
from compressor (3).
3. Disconnect the high pressure hose (6) from receiver.
(When reassembling)
• Apply compressor oil (DENSO CO. ND-OIL8) to the O-rings and
take care not to damage them.
W1014957
Steering Joint, Hose, Meter Cable, Oil Cooler Pipe and Hose
1. Remove the steering joint (1).
2. Disconnect the meter cable (2) from the engine.
3. Disconnect the delivery hose (3), oil cooler hose (4).
4. Remove the oil cooler pipe (5).
(When reassembling)
W1015254
Tightening torque
High pressure hose
retaining nut
11.8 to 14.7 N·m
1.2 to 1.5 kgf·m
8.7 to 10.8 ft-lbs
Low pressure hose
mounting screw
7.8 to 11.8 N·m
0.8 to 1.2 kgf·m
5.8 to 8.7 ft-lbs
(1) Condenser Slide Stopper
(2) Condenser
(3) Compressor (4) High Pressure Hose
(5) Low Pressure Hose
(6) High Pressure Hose
Tightening torque
Delivery hose retaining nut
22.6 to 27.6 N·m
2.2 to 2.8 kgf·m
16.2 to 19.9 ft-lbs
Oil cooler pipe nut
49.0 to 68.6 N·m
5.0 to 7.0 kgf·m
36.1 to 50.6 ft-lbs
Oil cooler hose retaining
45.1 to 53.0 N·m
4.6 to 5.4 kgf·m
33.3 to 39.0 ft-lbs
(1) Steering Joint
(2) Meter Cable
(3) Delivery Hose (4) Oil Cooler Hose
(5) Oil Cooler Pipe
KiSC issued 03, 2007 A