Kubota M105S, Workshop Manual

Page: 489 / 561

9-S43
M105S, WSM ELECTRICAL SYSTEM
Reassembling the Brush
1. Fit the brush with its sliding face in the clockwise direction when
viewed from front.
IMPORTANT
■
• Be sure to keep the two brushes deep in the brush holder.
Otherwise the rotor and the rear section can not be fitted
into position.
• Use a 4 mm hex. wrench to push the brushes into place.
• Using a pin-pointed (2 mm) punch, keep the brushes from
popping out.
2. Match the tally line of the front section with that of the rear
section.
3. Tighten the four screws, and draw out the pin-pointed punch out
of the brush holder.
W1049086
Bearing at Slip Ring Side
1. Lightly secure the rotor (1) with a vise to prevent damage, and
remove the bearing (2) with a puller (3).
W1049437
(1) Marking
(1) Rotor
(2) Bearing (3) Puller
KiSC issued 03, 2007 A